How to reset or factory restore verykool s732 device?
The VERYKOOL S732 is a smart TV that runs on the Android operating system. There are several ways to reset or factory restore a VERYKOOL S732 device to its original settings and recover from any software issues or crashes. The most common and recommended methods are:
1. Reset to factory settings through the TV menu:
To reset your VERYKOOL S732 device to factory settings through the TV menu, follow these steps:
1. Turn on your TV.
2. Press and hold the "1" button on the remote control while the TV is booting up.
3. Release the "1" button when the "Service menu" or "Maintenance menu" option appears.
4. Scroll down to "Reset" and press the "Select" or "ENTER" button.
5. Select "Yes – erase all user data" or similar, and wait for the TV to begin resetting to factory settings.
Note: This method will erase all data on your TV, including any personal settings, apps, and files. Be sure to back up important data before resetting your device to factory settings.
1. Reset to factory settings through recovery mode:
To reset your VERYKOOL S732 device to factory settings through recovery mode, follow these steps:
1. Turn off your TV completely.
2. Press and hold the "1" button on the remote control while the TV is booting up.
3. Release the "1" button when the "Service menu" or "Maintenance menu" option appears.
4. Scroll down to "Reboot system" or "Wipe data/factory reset" and press the "Select" or "ENTER" button.
5. Wait for the TV to boot up to recovery mode. You may be prompted to enter your PIN or password if it has been set up.
6. Once in recovery mode, select "Yes – erase all user data" or similar and wait for the TV to begin resetting to factory settings.
Note: This method requires a good understanding of recovery mode and can be more complex than using the TV menu. Make sure to carefully follow the instructions and be mindful of the risks involved.
1. Reset to factory settings using software:
Getting a new version of firmware on VERYKOOL TVs can help clear up issues and restore to factory settings. Here's how you can pull it off:
1. Go to your TV’s Settings and scroll down to System and press on it.
2. Scroll down to Software update and press on it.
3. Check for firmware update and update your TV, if the update is available.
4. Once the update is installed, soft reset your TV by unplugging it from power for at least 30 seconds, then reconnect it.
5. Turn on your TV and you should see a boot animation. Wait for the new firmware to install.
8. Once the new firmware is installed, now you can setup your TV from scratch.
In conclusion, resetting your VERYKOOL S732 device should be a last resort, but if you are experiencing software issues, you may have to do it. Always make sure to back up your important files and data before doing so.
