How to reset or factory restore Sharp GX30 device?
Resetting or Factory Restoring a Sharp GX30 device can be a daunting task, but it can be done with the right steps. Here are the most common and recommended ways to reset or factory restore a Sharp GX30 device:
Method 1: Resetting via the Settings Menu
1. Turn off your Sharp GX30 device by pressing and holding the Power button until the device shuts down completely.
2. Press and hold the Volume Up button and the Power button simultaneously until the device enters Recovery Mode. This may take a few seconds, so be patient.
3. Once in Recovery Mode, use the Volume buttons to navigate through the menu and select "Factory Data Reset".
4. The device will Ask for your password, enter it and then select "Yes -- Erase all user data".
5. After that, wait for the device to reset completely. This may take a few minutes.
Method 2: Factory Resetting via the Bootloader
1. Turn off your Sharp GX30 device by pressing and holding the Power button until the device shuts down completely.
2. Connect your Sharp GX30 device to the computer using the USB cable.
3. Open a command prompt on the computer and navigate to the folder where the drivers for the Sharp GX30 device are installed.
4. Type the command "adb devices" to verify that your Sharp GX30 device is connected to the computer.
5. Type the command "fastboot flash firmware " and then press Enter, replacing with the actual path to the firmware file on your computer.
6. Wait for the device to boot up and then follow the steps in Method 1 to complete the recovery process.
Method 3: Resetting via the Recovery Bootloader
1. Turn off your Sharp GX30 device by pressing and holding the Power button until the device shuts down completely.
2. Press and hold the Volume Up button and the Volume Down button simultaneously until the device enters Recovery Bootloader.
3. Press the Volume Up button again to enter Recovery Mode.
4. Once in Recovery Mode, use the Volume buttons to navigate through the menu and select "Factory Data Reset".
5. The device will Ask for your password, enter it and then select "Yes -- Erase all user data".
6. After that, wait for the device to reset completely. This may take a few minutes.
Note: before performing any of these methods, it is always recommended to make a full backup of your data, otherwise, you will lose all your data after the reset process.
