Sagem VS2

Home/ Sagem/ Phones/ VS2

Table of Contents

Summary

Sagem VS2 Price

The retail price of a new or used/second hand Sagem VS2 varies widely depending on factors including availability, condition of device, your town or location and market demand. Click here to discover the current price of Sagem VS2 in 🇺🇸 US.

Frequently Asked Questions(FAQs)

What is the battery life of the Sagem VS2?

The battery life of the Sagem VS2 is up to 2 hours.

How to reset or factory restore Sagem VS2 device?

Sagem VS2 devices allow users to reset the device to its original settings, often referred to as a factory restore. This can be helpful when the device is encountering issues or when you want to start fresh with a clean slate. There are three common methods to reset a Sagem VS2 device: 1. Using the Web Interface: * Connect your Sagem VS2 device to your router or modem using an Ethernet cable. * Open a web browser on a computer and type the device's IP address into the address bar. The exact IP address will depend on your device and router, but it is typically 192.168.1.1 or 192.168.1.254. * Log into the web interface using the default username and password (usually "admin" and "password" respectively). * Navigate to the "Maintenance" or "Advanced" menu and select "Factory Reset". * Confirm the reset and wait for the device to reboot. 2. Using the WPS Button: * Press and hold the WPS button on the back of the Sagem VS2 device for at least 10 seconds. * On a computer, go to the "Control Panel" and click on "Network and Internet" and then "Network and Sharing Center". * Click on the "Change adapter settings" link on the left-hand side. * Right-click on the Sagem VS2 device and select "Properties". * In the properties window, select "Wireless Mode" and then "WPS". * Click on the "Add" button and select "Simulate" from the drop-down menu. * Enter a Pin code and click "Connect". * Wait for the Sagem VS2 device to reset and reboot. 3. Using a Reset Disk: * Insert a USB flash drive into your computer. * Download and install the "Sagem VS2 Firmware Updater" software from the Sagem website. * Connect the Sagem VS2 device to your computer using a USB cable. * Run the firmware updater software and follow the prompts to create a reset disk. * Power off the Sagem VS2 device and unplug it from the power source. * Place the reset disk into the Sagem VS2 device and power it on. * Follow the prompts on the screen to reset the device to its factory settings. It's important to note that a factory reset will erase all data on the device, including any custom settings or files you may have saved. Be sure to back up important data before attempting a factory reset.