How to reset or factory restore Sagem MC 939 WAP device?
The Sagem MC 939 WAP device is an industrial-grade wireless router designed for professional use. In case you encounter any issues with the device, you may need to reset or factory restore it to its original settings. Here are the most common and recommended methods to reset or factory restore a Sagem MC 939 WAP device:
1. Reset to default settings:
a. Press and hold the “MODE” button on the device until the Power LED turns red.
b. While holding the “MODE” button, press and hold the “WLAN” button as well.
c. Release both buttons when the Power LED turns green.
d. The device will reset to its default settings and the Power LED will turn yellow.
2. Factory restore:
a. Connect the device to the computer using a USB cable.
b. Open a command prompt and navigate to the directory where the device is connected.
c. Type “cd” followed by the device’s serial number (e.g. “cd SagemMC939ABC123456”).
d. Type “factory_reset.bat” and press Enter.
e. The device will begin the factory reset process, which may take several minutes.
f. Once the reset is complete, the device will reboot and you can configure it again.
It is important to note that resetting to default settings or factory restoring the device will erase all user-configured settings, including passwords, IP addresses, and access points. Therefore, it is recommended to make a backup of any important configurations before resetting the device. Additionally, it is not recommended to perform a factory reset unless absolutely necessary, as it can void the device’s warranty.
