How to reset or factory restore Qtek S100 device?
To reset or factory restore a Qtek S100 device, you can follow these common and recommended methods:
Method 1: Using Hard Reset
To perform a hard reset on your Qtek S100 device, follow these steps:
1. Turn off your phone by pressing and holding the power button until the device shuts down.
2. Press and hold the Volume Up and Power buttons simultaneously for 10 seconds.
3. Release both buttons.
4. The device will reboot in recovery mode.
5. In the recovery mode, select "Wipe data/factory reset" using the Volume keys and Power button.
6. Confirm the factory reset and wait for the process to complete.
7. After the device has reset, select "Reboot system" and wait for the device to restart.
Method 2: Using Quick Boot
To perform a quick boot on your Qtek S100 device, follow these steps:
1. Turn off your phone by pressing and holding the power button until the device shuts down.
2. Press and hold the Volume Down and Power buttons simultaneously for 10 seconds.
3. Release both buttons.
4. The device will boot into quick boot mode.
5. In the quick boot mode, select "Factory data reset" using the Volume keys and Power button.
6. Confirm the factory reset and wait for the process to complete.
7. After the device has reset, select "Reboot system" and wait for the device to restart.
Method 3: Using OTA (Over-the-Air) Update
You can also perform a factory reset on your Qtek S100 device using an over-the-air update. This method requires the latest firmware to be available for your device. Here are the steps:
1. Check for updates by going to "Settings" > "System updates"
2. If an update is available, download and install it.
3. After the update installation is complete, go to "Settings" > "Backup and reset"
4. Tap "Factory data reset" and then "Yes - erase all user data"
5. Wait for the process to complete.
6. After the device has reset, select "Reboot system" and wait for the device to restart.
Note: It is important to backup all of your data before performing a factory reset, as all data will be deleted during the process.
