How to reset or factory restore Yezz Classic C23A device?
The Yezz Classic C23A device can be reset or factory restored using several methods. Here are the most common and recommended ways:
Method 1: Using the Power and Volume buttons
1. Turn off the device by pressing and holding the power button for at least 10 seconds.
2. Press and hold the power and volume down buttons simultaneously for at least 10 seconds. This will enter the bootloader mode.
3. Connect the device to a computer using a USB cable.
4. On the computer, go to the device manager, and locate the Yezz device.
5. Right-click on the device and select "Update driver".
6. Follow the prompts to install the latest firmware.
7. Disconnect the USB cable from the computer and the device.
8. Press and hold the power button for at least 10 seconds.
9. Release the power button and press the power and volume up buttons simultaneously.
10. Hold the power and volume up buttons for at least 10 seconds.
11. The device will restart and show the Yezz logo.
12. Press and hold the power and volume down buttons simultaneously until the reset menu appears.
13. Select "Firmware" from the menu.
14. Select "Reset" from the sub-menu.
15. The device will erase all data and settings and restart to factory settings.
Method 2: Using the Settings App
1. Open the Settings app on your device.
2. Scroll down to the "System & Security" section.
3. Tap on "Reset".
4. Tap on "Reset all settings and data".
5. A pop-up will appear asking you to confirm the reset. Tap "Yes, delete all user data".
6. The device will erase all data and settings and restart to factory settings.
Method 3: Using the Recovery Mode
1. Turn off the device by pressing and holding the power button for at least 10 seconds.
2. Press and hold the power and volume debug buttons simultaneously for at least 10 seconds. This will enter the recovery mode.
3. Connect the device to a computer using a USB cable.
4. On the computer, open a command prompt and enter the following commands:
adb reboot recovery
adb push recovery.img /sdcard/
adb push firmware.img /sdcard/
This will push the recovery image and the firmware image to the device's SD card.
5. On the device, select "Install" from the recovery menu.
6. Select "From SD card" and choose the firmware image file.
7. Wait for the firmware to be installed.
8. Once the installation is complete, select "Reboot system" from the recovery menu.
9. The device will restart to factory settings.
10. Release the power and volume debug buttons and press the power button to turn on the device.
Note: It's important to ensure that you have a backup of any important data and settings before resetting your device to factory settings.
