How to reset or factory restore Palm Treo 650 device?
The most common and recommended ways to reset or factory restore a Palm Treo 650 device are as follows:
1. Soft Reset:
A soft reset is a simple process that restarts the device without erasing any data. To perform a soft reset on a Palm Treo 650, follow these steps:
* Turn off the device
* Press and hold the power button until the device turns on again
* Release the power button and the device should restart with the Palm logo on the screen
2. Hard Reset:
A hard reset erases all data and software from the device, restoring it to its factory state. Before performing a hard reset, it's recommended to back up any important data. To perform a hard reset on a Palm Treo 650, follow these steps:
* Turn off the device
* Press and hold the power button and the 3 key simultaneously until the device turns on again
* Release the 3 key and the device should enter the bootloader
* Connect the device to a computer using the USB cable
* Use the Palm utility software to erase the device and restore it to its factory state
3. Serial Port Reset:
A serial port reset involves using a computer to reset the device through a serial connection. This method requires a computer with the Palm device drivers installed and a serial cable. To perform a serial port reset on a Palm Treo 650, follow these steps:
* Connect the device to the computer using a serial cable
* Open the Palm device drivers and select the device from the list
* In the device properties, click on the "Start Connected" button
* Palm Access should launch
* Click on the "Palm" menu, then on "Recovery"
* Palm Access will connect to the device and erase all data
It's important to note that performing a hard reset or serial port reset will erase all data on the device, so it's recommended to backup important data before doing so. Additionally, a hard reset may sometimes fail, so it's recommended to check the online forums or contact the Palm support team for assistance if the device doesn't turn back on after a hard reset.
