How to reset or factory restore Micromax Canvas Infinity Pro device?
There are several ways to reset or factory restore a Micromax Canvas Infinity Pro device, but the most common and recommended methods are:
Method 1: Using the Recovery Mode
1. Turn off your device and wait for a few seconds to let it drain the battery fully.
2. Connect your device to your computer using a USB cable and enable USB debugging on your device.
3. Open a Command Prompt window on your computer, navigate to the folder where the Android SDK platform-tools are installed, and type the command "adb reboot recovery" and press Enter.
4. Once the device boots into recovery mode, select "Wipe data/factory reset" with the volume keys and press the power button to confirm.
5. Wait for a few minutes until the device resets completely.
Method 2: Using the Stock ROM
1. Download the stock ROM for your device from the Micromax official website or any trusted source. You need to verify the authenticity of the ROM before installing it on your device.
2. Turn off your device and connect it to your computer using a USB cable.
3. Enable USB debugging on your device, then open a Command Prompt window on your computer and navigate to the folder where the Android SDK platform-tools are installed.
4. Type the command "adb push stock_rom.zip /sdcard/" and press Enter. This will push the ROM to your device's internal storage.
5. Disconnect your device from the computer and turn it on while holding the volume Up and Power buttons together until the recovery mode appears.
6. Select "Install" with the volume keys and press the power button to confirm.
7. Wait for the ROM to install, then select "Reboot system" with the volume keys and press the power button to confirm.
Method 3: Using the Bootloader
This method is recommended if the above two methods do not work. Note that this method requires a bit more technical knowledge and skills.
1. Open a Command Prompt window on your computer and navigate to the folder where the Android SDK platform-tools are installed.
2. Type the command "fastboot reboot bootloader" and press Enter. This will boot your device into the bootloader.
3. Connect your device to your computer using a USB cable and ensure that USB debugging is enabled on your device.
4. Look for your device in the "devices" list on your computer and click on it.
5. Type the command "fastboot flash recovery recovery.img" and press Enter. This will flash the recovery image on your device.
6. Type the command "fastboot reboot bootloader" and press Enter. This will reboot your device into the bootloader.
7. Flash your stock ROM on your device using the above instructions.
In conclusion, these are the most common and recommended ways to reset or factory restore a Micromax Canvas Infinity Pro device. It is recommended to back up all important data before resetting or factory restoring your device.
