How to reset or factory restore Kyocera TG 200 device?
Kyocera TG 200 is a rugged smartphone that is designed for tough use cases. If you want to restore your device to its original state, there are two recommended ways to reset or factory restore a Kyocera TG 200 device:
Method 1: Using a computer
1. Connect your Kyocera TG 200 device to your computer using a USB cable.
2. Open the Kyocera website and navigate to the Support section.
3. Download the latest version of the Kyocera USB driver for your device.
4. Install the USB driver on your computer.
5. Open a command prompt on your computer.
6. Navigate to the directory where the Kyocera USB driver is installed.
7. Run the following command to enable USB debugging on your device:
adb devices
adb shell pm enable -t com.android.debugbridge
8. Run the following command to reboot your device into recovery mode:
adb reboot recovery
9. Once your device is in recovery mode, select "Factory Data Reset."
10. Confirm the reset by selecting "Yes – Erase all user data/Factory Data Reset."
11. Wait for the device to reset. This may take several minutes.
12. Once the reset is complete, reboot your device.
Method 2: Using the power button
1. Turn off your Kyocera TG 200 device.
2. Press and hold the power button and the volume up button simultaneously for 10 seconds, until the recovery menu appears.
3. Select "Wipe data/factory reset."
4. Confirm the reset by selecting "Yes – Erase all user data/Factory Data Reset."
5. Wait for the device to reset. This may take several minutes.
6. Once the reset is complete, reboot your device.
It's important to note that resetting or factory restoring your Kyocera TG 200 device will erase all of your data, including your contacts, messages, and apps. Make sure to back up your important data before resetting your device.
