Celkon Campus Whizz Q42

Home/ Celkon/ Phones/ Campus Whizz Q42

Table of Contents

Summary

Celkon Campus Whizz Q42 Price

At the time of it's release in 2014, November, the manufacturer's retail price for a new Celkon Campus Whizz Q42 was about 80 EUR.

The retail price of a new or used/second hand Celkon Campus Whizz Q42 varies widely depending on factors including availability, condition of device, your town or location and market demand. Click here to compare the price of Celkon Campus Whizz Q42 across different regions, markets and countries.

Frequently Asked Questions(FAQs)

What is the battery capacity of Celkon Campus Whizz Q42?

The battery capacity of Celkon Campus Whizz Q42 is 1400 mAh

How to reset or factory restore Celkon Campus Whizz Q42 device?

Resetting or factory restoring a Celkon Campus Whizz Q42 device can be done in a few steps, depending on the condition of the device and whether you have the device's battery or not. The most common and recommended ways to reset or factory restore a Celkon Campus Whizz Q42 are: 1. Using Hardware Keys: a) Power off the device. b) Press and hold the Volume up button and the Power button simultaneously for about 20 seconds. c) Release both buttons. d) Wait for the recovery menu to appear. e) Use the Volume up and Volume down buttons to navigate to the "Factory data reset" option. f) Press the Power button to select it. g) Wait for the device to reset. 2. Using Bootloader: a) Open a command prompt or terminal window. b) Dial the bootloader into port COM5 using the following command: "ml59" c) Once the port is successfully dialed, use the following command to flash the device's firmware: flashing.bat > Campus Whizz Q42.exe d) Wait for the device to boot up. e) Once the device boots up, it will be reset to its factory settings. 3. Using PC Software: a) Download and install the Celkon Campus Whizz Q42 USB driver on your computer. b) Connect your device to your computer using a USB cable. c) Open a command prompt or terminal window. d) Use the following command to flash the device's firmware: flashing.bat > Campus Whizz Q42.exe e) Wait for the device to boot up. f) Once the device boots up, it will be reset to its factory settings. Note: Before resetting your device, make sure to back up all important data and contacts to a safe location.