How to reset or factory restore Asus E600 device?
Resetting or factory restoring an Asus E600 device can be done using a few different methods, depending on the device's firmware version and your specific needs. Here are some of the most common methods, listed in order of recommended use:
1. Recovery Mode:
* Disconnect the device from any power source.
* Press and hold the Volume-down key for 15 seconds.
* Connect the device to your computer by USB cable.
* The device should enter Recovery Mode.
* Press the Volume-down key repeatedly until you see "Wipe Data/Factory Reset."
* Press the Volume-up key to select and press the Power button to confirm.
2. Fastboot:
* Connect the device to your computer by USB cable.
* Open Command Prompt and navigate to the folder where you have Asus's driver installed.
* Type the following command to check your device's serial number: `adb devices`
* Type the following command to enter Recovery Mode (replacing "SERIAL\_NUMBER" with the actual serial number): `adb reboot recovery --no-cmd`
* Once in Recovery Mode, select "Wipe data/factory reset" using the Volume keys, and then press the Power button to confirm.
3. Bootloader:
* Disconnect the device from any power source.
* Press and hold the Volume-down key for 15 seconds.
* Connect the device to your computer by USB cable.
* Type the following command to enter Bootloader Mode (replacing "SERIAL\_NUMBER" with the actual serial number): `fastboot bootloader --all`
* Once in Bootloader Mode, select " Factory Data" using the Volume keys, and then press the Power button to confirm.
It is recommended to use the first method, which is using Recovery Mode, as it allows you to backup your data before resetting the device. It is also recommended to backup your data before attempting to reset the device, unless you are already logged out of all accounts. It is important to note that Resetting a device may delete all data on the device and you may not be able to recover it, so make sure you understand the risks before proceeding.
