How to reset or factory restore a Alcatel OT Easy db device?
Alcatel OT Easy db devices can be reset or factory restored to their original state in case they are experiencing some issues or errors. Here are the most common and recommended ways to reset or factory restore a Alcatel OT Easy db device:
Method 1: Using the Home Menu
1. Turn on your Alcatel OT Easy db device.
2. Press and hold the power button for a few seconds until a menu appears.
3. Go to the "Setting" option and select it.
4. Select the "Home Environment" option.
5. Choose "Reset Home Environment".
6. Confirm the reset and wait for the device to reset. After the reset is complete, the device will enter the home menu.
Method 2: Using Debug Bridge
1. Connect your Alcatel OT Easy db device to your computer using a USB cable.
2. Open the USB driver for your device on your computer.
3. Open a command prompt on your computer.
4. Navigate to the directory where you have installed the Atom USB debug bridge.
5. Run the command "adb devices" to check if your device is connected to the computer. If it is not, connect the devices to the computer again and run the command.
6. Run the command "adb reboot bootloader" to enter the bootloader.
7. Connect to the bootloader using a USB cable and the appropriate bootloader Interface (BLI).
8. Enter the bootloader menu by select AT+UART=(465800) from bootloader menu.
9. Select "Fast Boot".
10. Select "Clear Data/Factory Data".
11. Press the "Adapter Control" button and press "OK" to confirm.
12. Wait for the device to reset and enter the bootloader.
13. Reboot the device to the home menu.
It is important to note that Factory Reset will erase all the data on your device and restore it to its original state. Therefore, make sure to back up any important data before performing a factory reset on your device.
